黄姜皂素纤维渣的氯化锌热解特性

张彩香; 王焰新; 甘义群

黄姜皂素纤维渣的氯化锌热解特性

中国地质大学环境学院湖北武汉 430074

基金项目:

国家杰出青年科学基金项目 40425001

国家863计划课题 2004AA01050

详细信息

作者简介:
张彩香(1970一)，女，博士研究生。主要从事固体废物资源化利用、水污染控制等方面研究.E-mail：zencui48@ctgu.edo.cn

中图分类号: TQ424.1
计量
- 文章访问数: 3484
- HTML全文浏览量: 531
- PDF下载量: 8
- 被引次数: 0
出版历程
- 收稿日期: 2005-07-18
- 刊出日期: 2005-09-25

Pyrolysis of Cellulose Residue from Disogenin with Zinc Chloride

School of Environmental Studies，China University of Geosciences，Wuhan 430074，China

摘要

摘要: 探讨氯化锌活化黄姜皂素纤维渣的机理, 应用TG-FTIR联用技术考察了黄姜皂素纤维渣的氯化锌热解特性.不同的配比、氛围及升温速率对热解均有影响.低温氧化有利于活性炭的形成, 但高温氧气的存在对炭体烧失较大; 氯化锌与原料的配比越高, 对原料的侵蚀性越强, 采取相应的活化温度较低; 升温速率越低越有利于原料中有机质蓄积热量热解, 相应的活化温度也越低; 红外光谱图也表示挥发分产物的出现与热重分析相符, 没有时间滞后现象.因此, 确定制备活性炭的初步工艺为先在300℃左右低温炭化, 再在保护气氛中(如N2) 500℃左右活化, 升温速率10K/min左右.工业生产条件下, 活化温度最高不宜超过650℃.
- 纤维渣 /
- 活性炭 /
- 氯化锌 /
- TG-FTIR
Abstract: The understanding of the mechanism of activated carbon prepared from cellulose residues from the acid hydrolysis of Discorea zingiberensis C.H.Wright may help us to investigate systematically, with the help of TG-FTIR, the pyrolysis of the carbonization with ZnCl₂ on different conditions. The pyrolysis was related to such different conditions as impregnation ratio, atmosphere, and heating rate. At a low temperature, oxygen prompts the formation of activated carbon, but results in the loss of carbon at a high temperature. The lower activated temperature could be adopted on the condition that the higher impregnation ratio is employed since more ZnCl₂ may erode raw material into a harder one. The organic matters of raw material can store more heat for the decomposition at a lower heating rate corresponding to a lower activated temperature. The trends for gas emission analyzed by FTIR were similar to that by TG, which proved that there was no time delay between them. Accordingly, the primary process for the preparation of activated carbon is determined as follows: the raw material was carbonized at about 300℃, then was activated at about 500℃ with deoxidizing atmosphere (eg.N₂) at the heating rate of 10 k/min. It is recommended that the highest temperature for activation should not go beyond 650℃ even on the condition of the industrial production.
- cellulose residue /
- activated carbon /
- ZnCl2 /
- TG-FTIR

HTML全文

图 1 黄姜皂素纤维渣燃烧失重过程曲线

Fig. 1. Weight loss curves of raw material

下载: 全尺寸图片幻灯片

图 2 氯化锌活化纤维渣的热解曲线

Fig. 2. Weight loss curves of carbonation with ZnCl₂

下载: 全尺寸图片幻灯片

图 3 相同温度不同活化条件对释放气体的影响

a.300 ℃时配比的影响; b.520 ℃氛围的影响; c.474 ℃升温速率的影响

Fig. 3. FTIR spectrum of evolved gas at the same temperature

下载: 全尺寸图片幻灯片

表 1 姜皂素生产纤维渣的基本特性

Table 1. Fundamental properties of raw material

参考文献(6)

Huang, B. Z., Hu, S. Y., Lin, Q. M., 1997. Analysing the course of pyrolysis of activated carbon production of zine chloride method by thermal analysis. Journal of Fujian College ofForestry, 17 (3): 235-240 (in Chinese with English abstract).
Ferrasse, J. H., Chavez, S., Arlabosse, P., etal., 2003. Chemometrics as a t001 for the analysis of evolved gas during the thermal treatment of sewage sludge using coupied TG-FrIR. Thermochimica Acta, 404: 97-108. doi: 10.1016/S0040-6031(03)00064-9
Ramesh, K. S., Jan, B. W., Vicki, L. B., etal., 2004. Characterization of chars from pyrolysis of lignin. Fuel, 83: 1469-1482. doi: 10.1016/j.fuel.2003.11.015
Xie, Q., Ding, S. G., Le, Z., 1995. Effect of slow carbonization and partial oxidation on preparation of activated carbon from coal. Journal of fuel Chemistry and Technology, 23 (3): 242-247 (in Chinese with English abstract).
黄碧中, 胡淑宜, 林启模, 1997. 热分析法解析氯化活化法的热解过程. 福建林学院学报, 17 (3): 235-240. https://www.cnki.com.cn/Article/CJFDTOTAL-FJLB199703010.htm
解强, 丁曙光, 乐政, 1995. 缓慢炭化部分氧化对制备煤质活性炭的影响. 燃料化学学报, 23 (3): 242-247. https://www.cnki.com.cn/Article/CJFDTOTAL-RLHX503.003.htm